50t Diesel Burning Heating Asphalt Bitumen Storage Tank
Bitumen storage and heating tanks will be heated by hot thermal oil through external thermal oil boiler, keeping asphalt liquid with high temperature. They are widely used for asphalt batching plants, aggregate stockpiles and asphalt storage terminals and other areas wherever thermal oil boiler is available for suppling high temperature thermal oil. Horizontal tank and vertical tank both are available, round shaped storage tank and square shaped storage tank are optional, with capacities range from 30m3 to 50m3.
1, 40-foot container design
2, 50t storage capacity
3, BV classification society certification
4, Internal heat transfer oil heating
5, Optional agitator
6, Asphalt pipeline is built-in, easy to install on site
| Asphalt Tank |
50t cylindrical can thermal oil heating asphalt tank asphalt mixing plant component |
| Type |
heating asphalt Tank |
| Capacity |
50t |
| Size |
40HQ container |
| Use |
storage and heating of asphalt |
| Keep warm |
100mm rock wool |
Features
The fuel asphalt heating tank has a high degree of automation. The overall equipment is automatically controlled and equipped with manual control, which can be switched freely.
The biggest feature of the asphalt tank is fast heating, which can not only produce high-temperature asphalt in large quantities, but also save heat energy, temporarily extract a small amount of hot asphalt, and generally produce hot asphalt at 160 ° C within 3 hours. Low pressure and high temperature, safe and sanitary, using "partial take out asphalt device", can quickly take out high temperature asphalt from large asphalt oil tanks, without the need to heat the asphalt tank as a whole.
1) Temperature control: Set the maximum temperature and the minimum temperature to reach the maximum temperature, the heating will automatically stop, and it will automatically enter the thermal insulation state.
2) Preheating: High-efficiency independent preheating circulation system, which electrically heats the heat transfer oil, uses heat transfer oil as the heat medium, and preheats the pump valve and the asphalt pipeline. The control system monitors the preheating system through sensors to prevent fires.
3) Large cycle: It is a circulation in the tank. When the asphalt in the high temperature zone reaches the operating temperature but does not need to extract the asphalt, it can be switched to a large cycle to increase the temperature in the entire tank and make the asphalt fluid. .
4) Circulation in high-temperature area: It can keep the asphalt in the high temperature area to reach the operating temperature, and the temperature is consistent
Precautions
1. When asphalt is loaded for the first time, please open the exhaust valve so that the asphalt can enter the heater smoothly.
2. Before starting the asphalt pump, ensure that the asphalt pump and pipeline are fully preheated.
3. When using heat transfer oil, pay attention to dehydration first, and the circulation pump is always in a circulating state.
4. When the asphalt is warmed, please pay attention to the instructions of the thermometer and pump out the high-temperature asphalt in time. If the temperature is too high and you don't need to raise it, please start the internal circulation to cool down quickly.
Product Tags:
|
|
50t Diesel Asphalt Bitumen Storage Tank Burning Heating Centralized Control Images
|
